Fiber cleaver, optical fiber cleaver CT-30A, FC-6S sumitomo fiber cleaver

• Company : Shenzhen Teco Optic Co., Ltd
• Region : Guangdong , China
• Category : Telecommunications > Fiber Optic Equipment
• Specification : Specification Bare fiber diameter 125µm Outercoat diameter 0.25?~0.9? Fiber type Single tube fiber and Ribbon fiber?exchangeable? Cleaved length 5~30? Cleaved angle 0.5° blade life 0.5°-12,000cleaves Mode Semiautomatic Dimension 58?(W)×55(D)?×48?(H) Weight
• Quantity : 1
• Price : Negotiated
• Contact Person : Linn Tan|||sales manager
• Telephone :
• Fax :
• Mobile phone :
• Website : http://www.op-teco.com
• Email : [email protected]
• Instant Messenger : Skye: tecosales1
• Update : Jun/10/2014

• Product Details

  Usage and Safety Regulation: ?Read this description, before using Cleaver and keep description with Cleaver . ?Using Cleaver please be cautious of the following particulars and prevent your body and property from harm and use carefully and usefully. ? ? Keep Cleaver away from water. ?Place Cleaver away from humid and dusty place. ?High temperature causes transforming, so keep it in normal temperature. ?Be careful with serious impact on it. ?Be sure that the stripped fiber length should be at least 12mm or longer. ?Clean the Cutting Edge Rubber Pad regularly with alcohol. Try not to use acetone or corrosive solvent when you clean the rubber pad. ?Keep the fiber holder clean to ensure no dust in it. 1. Operation Procedure of Products: 1.Open the body cover, and put the stripped fiber on the v-groove. And make sure that the cleave length is set as per operators’ intended length. 2.Push the Blade Carriage to the Front, then close the presser to fix the fiber. 3.Close the cover and make sure that the end of the fiber is sticking out of the rubber pad exactly in a straight line. 4.Push the blade carriage to the rear until it stops. 5. Open the cover of the body. 6. Take out the cleaved fiber with care in order not to bring the harm to the end face of fiber. 7. For the continuous operation, remove the cleaved fiber, in this process, be careful not to get injured by the cutting edge. 2. Blade Replacement & Blade Position Adjustment ?The cutting spots from 1 to 16 are marked on the blade. ?When it does not cleaves the fiber normally, clean the rubber pad and the edge of the blade with an-soaked swap.(But, do not use acetone or solvent when you clean the rubber pad.) ?However, if it still does not cleave the fiber properly, it means the cutting spot edge is fully used. So you need to change the cleaving position. The blade setting consists of 3 posit

Company Product

Related Product