- Company : Shandong Luteng Building Equipment Co., Ltd.
- Region : Shandong , China
- Category : Apparel & Clothing > Wedding Apparel
- Quantity : 300set/month
- Contact Person : nobel.liu|||sales
- Telephone :
- Fax :
- Mobile phone :
- Website : www.lutengmachinery.com
- Email : [email protected]
- Update : Mar/17/2019
Product Details
Numerical Control Steel Bar Straightening and Cutting Machine SLT5-12 (Automatic computer numerical control) The steel straightening and cutting machine is one of the steel rebar processing machines. It is used for straightening and cutting the steel rebar with diameter below 14 mm. It is composed of straightening tube, traversing mechanism, cutting mechanism, steel bar fixed length frame, frame and driving device. The steel bar passing through the aligning cylinder is straightened. When the steel bar is adjusted to the predetermined length, the hammer head hammers on the knife rest to cut off the steel bar, and the cut steel bar falls into the material rack. Due to the action of spring, the cutter table returns to the original position to complete a cycle 1. The advanced goaf is operated to check whether the bearing, hammer head, cutter or shear gear are normal. 2. Select appropriate aligning block, traction wheel groove and running speed according to the diameter of the steel bar. The diameter of the aligning block should be 2-5 mm larger than the steel bar, and the width of the traction wheel groove should be the same as the diameter of the steel bar. Transmission speed should be selected according to the diameter, large diameter should be selected slow, after adjustment qualified before feeding. 3. The end of the steel bar should be removed before feeding. The steel reinforcement should first pass through the steel tube and then enter the guide tube and straightening tube, so as to prevent injuries from popping up when each steel plate is close to the straightening end. 4. After cutting off 3 or 4 steel bars, stop the steel bar to check the length. When the allowable deviation is exceeded, the limit switch or gauge plate should be adjusted. 5. If the steel bar is still slowly bent after straightening, it can gradually increase the offset of the aligning block unti
